<- Back to Tutorials

Your guide to Wrinkle Retreat Light Therapy Face Mask

Watch this tutorial to master our Wrinkle Retreat Light Therapy Face Mask for glowing skin.

How to use Wrinkle Retreat Light Therapy Face Mask

Before First Use

Light Sensitivity Test

We highly recommend users perform a light sensitivity test before their first use of the device.

  1. Place the device on the inner forearm.
  2. Turn on the device to start a treatment.
  3. Wait until the treatment is done. The full treatment will take 10 minutes to complete.
  4. If your skin feels hot or uncomfortable during the treatment, stop immediately! You might be sensitive to light.
  5. The device will automatically turn off after the treatment is done. Remove the device and wait for at least 24 hours before your next treatment.

Check your skin regularly over those 24 hours. If your skin appears red and/or itchy, the device is unsuitable for you. In case of sensitivity to the light, please contact customer support.


General Use

  1. Prior to using the device, make sure the controller is fully charged and that the Protective Eyewear is inserted in the mask. The Protective Eyewear is required in order to use the device- please ensure they are properly installed each time you use the device.
  2. Clean your face with a cleanser.
  3. Make sure the controller is unplugged from the charger and place the device on your face.
  4. Turn on the device by pressing the ON/OFF button on the controller for 1·2 seconds. The lights on the controller will turn on when the button is pushed for 1 full second, indicating that the device is turned on. Note: Device should only be turned on when secured on your face.
    • The device's default treatment is anti-aging. The word "Anti-Aging" will light up on the controller.
    • To switch to the anti-acne treatment, press the ON/OFF button shortly (less than one second). The word Anti-Acne will light up.
  5. Enjoy the treatment.
    • The device switches off automatically after a 10-minute treatment session.
    • You may stop the treatment at any time by pressing the ON/OFF button for more than one second.
  6. Remove the device from the treatment area.
  7. You may clean the device using a water-based wipe or a 70% alcohol wipe. Ensure the device is not connected to the power supply when cleaning. Do not submerge the device in water or apply water directly to the device.
  8. Repeat these steps based upon the treatment protocol described next in water or apply water directly to the device.

Treatment Protocol

Use the device 10 minutes per day, 3 days per week for a minimum of 4 weeks. After that, you can continue using the device as desired, based on your lifestyle and skin condition.